FURUNO FA-150 FILETYPE PDF
Furuno USA Inc Automatic Identification Systems . Installation Manual CLASS A AIS Model FA PRODUCT NAME: U-AIS TRANSPONDER SAFETY .. For FA to FA retrofits, use the optional replacement kit (OP). .. File Type: PDF File Type Extension: pdf MIME Type: application/pdf PDF Version: FA OPERATORS MANUAL details for FCC ID ADB9ZWFA made by Furuno USA Inc. Document Includes User Manual OPERATORS MANUAL. FURUNO will assume no responsibility for the damage caused by improper use or The FURUNO AIS (Automatic Identification System) model FA or FA- Note: The file name is composed of a single alphabet, the file type, and.
|Country:||Antigua & Barbuda|
|Published (Last):||23 October 2015|
|PDF File Size:||11.20 Mb|
|ePub File Size:||17.51 Mb|
|Price:||Free* [*Free Regsitration Required]|
Note however that the 2nd targetalarm zone is available only when the 1st target alarm zone is active.
Remove the retaining ring and ball. Yes in the US. Typical false echoes areshown below. Extend trails filetupe 12 hours. TTSymbolMeaningImmediately after acquisition, this plotting symbol is shown inbroken lines.
Push the left button again. Monitor brilliance should be adjusted before adjusting relativebrilliance levels on the BRILL menu to be explained later. Fjruno the trackball to select the MARK box at the left side of the screen. To erase the data for the number selected, hitthe left button again. For that reason you may want to adjust the recording interval toconserve the memory.
What’s missing? Tell us about it.
Push the left button to enter the reference mark. This feature isavailable with an installation preset. Formattingprepares the recording surface of the card for use with the system, and deletesall data recorded in the memory card. Push the right button four times to close the menu.
Furuno FAR(-BB) : Marine RADAR User Manual
Right-click the MENU box to open the menu. See fw-150 table below fordetails. In some old AIS units there was the methods put on tge net but i have tried to find them without success.
Compass-stabilized with reference to northStern-up: Information that is exchanged includes static, dynamic, voyage related data, as well as short safety-related messages.
Select the port and alarm signals to output as follows: Rain and snowClutter can be acquired and tracked as targets. The user can create a radarmap on-real time while using the radar for navigation or at leisure time at anchoror while the radar is not being used.
Furuno FA AIS – AM Wholesale
Originally Posted by skiggy Push the right button three times to close the menu. To turnoff the radar, press the switch again.
The map data can be saved tofacilitate repeated use on a routine navigation area. The default specifications of each brillianceset are is in the table below. Offset from transducer, in meters see notes 1 and 2 3.
For that reason adjustthem carefully. The antenna stops in stand-by and rotates in transmit.
This radar equipment contains complex modules in which faultdiagnosis and repair down to component level are not practicable byusers. Sequential message identifier, 0 to Each radar curuno receivedcauses it to transmit a response which is swept repetitively across the completeradar frequency band.
Page 2 The paper used in this manualis elemental chlorine free. You may push the scrollwheel again to skip a place. Select a range then push the left button.
This is due to an error in the position fixing system GPS, Loran, etc. Note that a display mode cannot be selectedwhen the menu is open. Right-click the MENU box at the right side of the screen to open the menu. Tx repetitionSecond-traceechoFalse echorangeActual rangeSecond-trace echoesTo reject second-trace echoes: Thedifference from normal head-up presentation lies in the orientation of the bearingscale.
A new dot is added at preset time intervals until thepreset number is reached. You can set up this window as follows: BB code is On.